• .___ H_ o_m_ e_L_i_n_k_® __________________________________________________ _
Applies to vehicles : with Homelink® un iversal remo te con tr ol
Reprogramming a single button
A HomeLink® button can be reprogrammed individually
without affecting the other button a/locations.
Programming the overhead keypad
- Press the appropriate Homeli nk® button un til the indi-
cator light begins flashing slowly.
At the radiator grille
1. Point the original remote control to the middle of the
radiator grille of your vehicle =>
page 142, fig. 154.
2. Hold the original remote control at a distance between 0-
6 in. (0-15 cm) (use the shortest distance possible).
3. Press and hold the act ivation button on the remote
control.
4. The emergency flashers will flash
three times (after
about
15-60 seconds) when the programming is
successful. Now release the button on the remote
control.
- If the device ut ili zes a rolling code, please follow phase 3
of =>
page 142, "Programming the Homelink® trans-
mitter" fo r rolling code programming.
This procedure will cause the existing programming on the
Homelink ® button to be erased! •
Ap pli es to vehicles: with Home li nk® unive rsal remote contro l
Erasing the programming of the Homelink ®
transmitter
When you erase the programming, the programming on
all three of the transmitter channels with be lost!
- Perform steps 1 to 4 as described on => page 142, "Phase
1: programming the overhead keypad".
When completed, the Homelink ® system will be in the program -
ming mode and is then ready to learn the codes for remote
controlled devices.
[ i ] Tips
• Programmed buttons cannot be erased individually.
• For security reasons you are advised to erase the programming
of the Homelink ® system before you sell your vehicle. •
To Next Page
Loading...
