Driver information display
Memories
The trip computer is equipped with two fully automatic
memories.
Fig. 18 Trip computer
display: memory level 1
You can switch between the trip computer 1 and 2 by pressing the
Reset button @ => fig. 19.
You can tel l which memory level is currently active by the number in
the display => fig . 18. The data from the single -trip memory
(memory leve l 1) is being displayed if a
1 appears in the disp lay. If a
2 is shown , then the data from the total -trip memory is being
displayed (memory leve l 2).
Single-trip memory (Trip computer 1)
The single -trip memory stores the trip information from the time the
ignition is turned on until it is turned off. If the trip is continued
within 2 hours from the time the ignition was turned off, the new
data will be included in the calcu lation of the current trip informa -
tion. If the trip is interrupted for
more than 2 hours th e memory is
reset automatica I ly.
Total-trip memory (Trip computer 2)
Unlike the single -trip memory, the total -trip memory is not reset
automatically . This permits you to evaluate your driving data for the
entire period between manua l resets . •
Operation
The trip computer is controlled by two switches on the
windshield wiper lever.
---®
Fig. 19 Windshield
wiper lever: controls
for the trip computer
- Push the function selector switch up or down @
~
fig. 19. Thi s will ca use the five dist in ct tr ip computer
functions to be displayed one after another.
The trip computer will not operate unless the ignition is on. When
you turn on the ignition , the function that was in use when you last
turned the ignition off will be displayed.
For example , in addition to the trip computer information, the direc-
tion of the navigation system * is also disp layed . To switch the
display between the different information, tap the Reset button @
briefly.
Setting values to zero
To delete one current value from the trip computer, select the
desired function and press the Reset button
@ for at least one
second. The following values can be set to zero
individually using
the Reset button:
• Average fuel mileage
• Average speed
• Elapsed time
To Next Page
Loading...
