• Distance
In addition, all the values in the single -trip or the total -trip memory
can be deleted simultaneously~ page 25.
[ i ] Tips
All stored values will be lost if the veh icle battery is disconnected. •
Basic Settings for the trip computer
The
MM/* or the radio operating unit is used for setting
the trip computer's basic settings.
Fig. 20 Display: Trip
computer
- Select: Function button [CARI> Instrument cluster> On-
board computer 1
or On-board computer 2.
The values in the single-trip or the total-trip memory can all be reset
to zero at the same time under
Reset in the menu.
In addition, you can determine what information from the trip
computer should be shown in the instrument cluster disp lay. If one
of the pieces of driver information is turned
Off , that driver informa -
tion wil l not be shown in the display. The information wi ll continue
to be calculated by the trip computer and can be turned back
On at
any time . •
Controls and equip -
ment
Driv e r information display
Speed warning system
Overview
The speed warning system helps you to keep your driving
speed below a set speed limit.
The speed warning system warns if the driver exceeds a previously
stored maximum speed. A warning tone wi ll sound as soon as the
vehic le speed exceeds the set speed by about 3 mph (3 km/hl. At the
same time, a warning symbol appears in the display. The symbol's
appearance might be different in some models.
The speed warning system has
two warning thresholds that func -
tion independently of each other and that have somewhat different
purposes:
Speed warning 1
You can use speed warning 1 to set the maximum speed while you
are driving . This setting w ill remain in effect until you turn off the
ignition, assuming that you have not changed or reset the setting.
The speed warning symbol
E) (USA models)/ 8 (Canada models) in
the warning 1 disp lay appears when you exceed the maximum
speed. It goes out when the speed falls below the stored maximum
speed .
The speed warn ing symbol wil l also go out if the speed exceeds the
stored maximum speed by more than about 25 mph (40 km/h) for at
least 10 seconds. The stored maximum speed is deleted.
Setting speed warning 1
~
page 26.
Speed warning 2
Storing warning 2 is recommended if you always want to be
reminded of a certain speed, for example when you are traveling in
a country that has a general maximum speed limit, or if you do not
want to exceed a specified speed for winter tires. _.,,
I •
•
To Next Page
Loading...
