Audi Q5 2010 - Page 86

Seats and storage
Attach the roof rack only at the attachment points on the roof
railing. On the inside of the roof railing there are two holes for
attaching the rear end of the roof rack. To prevent confusing the
front and rear roof rack attachments, there are three holes on the
lef t and two holes on the right for mounting the front part of the
roof rack =>
page 83, fig. 87.
The roof racks have a sticker on the left side underneath to identify
front and rear.
& WARNING
When installing the roof rack, make sure the sticker is on the left
side of the vehicle and faces the stamped arrow in the drive
direction. •
Installing a roof rack
N
"'
8
ti:
.,
a,
Fig. 88 Roof railing:
positioning the roof
rack
Fig. 89 Roof railing:
installing a roof rack
The roof rack set consists of a front and rear roof rack, the
cover profile and a socket wrench.
- Open the cap
G)
~ fig. 89.
- Before mounting the roof rack, use the socket wrench @
and loosen the left and right screw in the direction of @ .
- Clean the attachment points on the roof railing as well as
the roof rack rubber washers © -
- Carefully place the roof rack over the holes in the roof
railing~ fig. 88.
- Place the pins © into the holes. The claw © must
engage into the edge of the roof railing.
- Make sure the rubber washer © lays flat on the roof
railing.
- Tighten the left and right screws using the socket wrench
@ in direction
@.
- To reach the 4 ft lb (6 Nm) tightening specification
needed, both arrows on the socket wrench must align .
- Repeat this procedure on the second roof rack.