Audi Q5 2017 - Page 34

Installing
Installation is carried out in reverse order; note the following:
Note
♦ Manual release cable -2- should not be in contact with parking
lock lever -1- to avoid transmission of mechanical vibration.
♦ Manual release cable -2- should therefore be aligned so that
there is a small clearance of dimension -a- and -b-.
– Check manual release mechanism for parking lock
⇒ page 22 .
Tightening torques
♦ ⇒ “1.2 Exploded view - manual release mechanism for parking
lock”, page 16
♦ ⇒ General body repairs, exterior; Rep. gr. 66 ; Strips / trim
panels / extensions; Exploded view - heat shield
♦ ⇒ General body repairs, exterior; Rep. gr. 66 ; Noise insula‐
tion; Exploded view - noise insulation
1.8.2 Removing and installing manual release
cable for parking lock (front) - Q5
Removing
WARNING
Accident risk; vehicle can start rolling.
♦ Pull up parking brake button to apply electromechanical
parking brake.
– Remove centre console ⇒ General body repairs, interior; Rep.
gr. 68 ; Centre console; Removing and installing centre con‐
sole .
– Remove insulation.
– Release catches -arrows A- and move sleeve -1- on manual
release cable in direction of -arrow B-.
– Disengage manual release cable (rear) from manual release
cable (front) -arrow C-.
Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
30 Rep. gr.34 - Controls, housing