– Check whether splines of gear sensor - G676- are aligned with
splines of parking lock shaft.
– Tighten securing bolt -arrow- to specified torque.
Note
When installing parking lock solenoid - N486- make sure that
dowel pin is correctly seated.
– Screw in both securing bolts -arrows- while spring pressure is
released and tighten to specified torque.
– To do so, use a roll-pin drift to turn parking lock shaft approx.
3° against spring pressure.
Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
36 Rep. gr.34 - Controls, housing
To Next Page
Loading...
