a,
a,
.....
N
r--
N
.....
0
0
0:
co
@ Tips
The discharged battery must be properly con-
nected to the vehicle's electrical system .
When jump starting or charg ing the battery,
never connect the negative ground cable to
the battery negative post because the battery
manager system must be able to detect the
battery's state of charge. Always connect the
negative ground cable to the negative ground
post of the battery manager control unit.
Use of jumper cables
Make sure to connect the jumper cable clamps in
exactly the order described below!
Fig. 225 Engine compartment: Connectors fo r jumper ca-
bles and charger
Fig. 226 Jump starting with the bat tery of another vehicle:
@ booster battery, @ discharged vehicle battery
The procedure described below for connecting
jumper cables is intended to prov ide a jump start
for your vehicle.
Hybrid drive*: read the impo rtant information
concerning a dead high voltage battery under
¢page 107.
Emergency situations
Vehicle with discharged battery:
.,. Turn off lights and accessories, move lever of
automatic transmission to N (Neutral) or P
(Park) and set parking brake.
Connect POSITIVE(+) to POSITIVE(+) (red)
"' Remove the cover
CD by pressing on the arrow
¢fig. 225 .
.,. Open the cover @ on the pos itive terminal.
1. Connect one end of the red positive cab le on
the
jump start bolt ¢ fig. 226 CD (Bolts un -
der cover = "positive") of the vehicle to be
started @ .
2. Connect the other end to the positive termi-
nal @ of the booster battery @ .
Connect NEGATIVE(-) to NEGATIVE(-)
(black)
3. Connect one end of the black negative cable
to the negative term i nal @ of the booster
battery @ .
4. Connect the other end of the black negative
cable to the
jump start bolt @ (Bolts with
hex head= "negative") of the vehicle to be
started @ .
Starting the engine
.,. Start the engine of the vehicle with the booster
battery @ . Run the engine at a moderate
speed .
.,. Start engine with discharged vehicle battery @
in the usual manner .
.,. If the engine fails to start: do not keep the
starter cranking for longer than 10 seconds.
Wait for about 30 seconds and then try again .
.,. With engine running, remove jumper cables
from both vehicles in t he exact
reverse order.
"' Close the cover @ on the positive terminal and
re- install the cover
CD<=> fig. 225.
The battery is vented to the outside to prevent
gases from entering the vehicle interior. Make
sure that the jumper clamps are well connected
with their
metal parts in full contact with the
batte ry term inals. .,.
267
To Next Page
Loading...
