Audi Q5 2024 - Charging settings

8080127218H
High-voltage system
If the charging connector cannot be removed, you
must unlock it manually > page 130.
If you cannot disconnect the charging connector
from the charging station, authenticate yourself
again at the charging station and then try again
to disconnect the charging connector. If you still
cannot disconnect the charging connector from.
the charging station, contact the charging sta-
tion operator.
—Do not disconnect the charging cable from
the socket or the vehicle charging port while
the vehicle is charging. End the charging
process before removing the charging cable
from the socket in order to reduce the risk
of damaging the connector contacts from
sparks.
= If the charging unit is damaged, do not
charge using the charging port to reduce the
risk of injury.
= If the charging unit is damaged or the charg-
ing port door cannot close or is missing,
drive immediately to an authorized Audi
dealer or authorized Audi Service Facility
and have the malfunction corrected to re-
duce the risk of injury.
If you drive with the charging unit open, both
the charging port door and the electronics in-
stalled behind it could be damaged. Check
each time after charging if the port door is
locked before you start driving the vehicle.
— If the parking brake is set, it could create
noises when the charging connector is con-
nected.
— Remove ice and snow in the charging unit
using a hand brush and solvent-free deicing
spray.
~The vehicle reception systems, such as radio
reception, may be limited during charging.
Applies to: vehicles with plug: hybrid drive
The charging display is an LED light on the charg-
ing unit @ > page 128, fig. 102 that indicates
the charging status. The following table explains
the displays.
Vehicle charging system is in sleep mode. A timer may be active,
off but charging has not started yet.
Charging process is interrupted.
White |Pulsating/flashing Connection between the power source and the vehicle is being
established.
Pulsating The high-voltage battery is charging.
Green Flashing Atimer is active, but charging has not started yet.
Illuminated High-voltage battery charging process is completed. >
129
OwnersManuals2.com