Audi Q5 2024 - Charging Settings

808012721BH
High-voltage system
» Drive to an authorized Audi dealer or author-
ized Audi Service Facility immediately to have
the malfunction corrected.
Manually releasing the charging connector
Ifyou are not able to pull the charging connector
out of the vehicle charging port, there may be a
malfunction. You must use the manual release to
release the vehicle charging connector.
Requirement: the “P” selector lever position
must be selected and the vehicle must be un-
locked.
» End the charging process page 128, Ending
the charging process.
» Open the luggage compartment lid.
» Turn the cap counterclockwise and fold the cov-
er © fig. 103 upward.
» Loosen the yellow loop @) from the retainer
and then pull on the loop carefully >@).
» Remove the charging connector.
> After releasing manually, secure the loop on
the retainer and close the cover.
> Drive to an authorized Audi dealer or author-
ized Audi Service Facility immediately to have
the malfunction corrected.
If the charging connector still cannot be removed
after using the manual release, there is still a
malfunction. The charging connector could also
be frozen in place if the temperatures are below
freezing. See an authorized Audi dealer or au-
thorized Audi Service Facility for assistance in all
cases.
© Note
Only pull on the loop until you feel resistance.
You will not hear it release. If you continue to
pull, you could damage the manual release
mechanism.
Messages
Applies to: vehicles with plug-in hybrid drive
If the [J indicator light turns on, then the range
is low or very low. Charge the high-voltage bat-
tery.
Charging settings
Selecting a charging mode
You can select if your vehicle should start charg-
ing immediately, or if it should start charging af-
ter a delay.
Immediate charging mode
The charging process will start immediately after
the charging connector has been plugged in and
the charging station has been activated, if re-
quired.
> Press the & @ © page 128, fig. 102 button on
the charging unit, or
» Applies to: MMI: Select on the home screen:
VEHICLE > Charging & Efficiency > Charging >
Ss.
A colored bar in the button will light up when im-
mediate charging mode is active. The LED in the
button of the charging unit will turn on.
Timer charging mode
The charging process will start after a delay,
based on a timer that has already been set and
activated page 137.
> Press the @) page 128, fig. 102 button on
the charging unit, or
» Applies to: MMI: Select on the home screen:
VEHICLE > Charging & Efficiency > Charging >
s.
When timer charging mode is active, Timer
charging mode will be displayed in the MMI. The
LED in the button of the charging unit will turn
on.
Timer
Applies to: with plug-in hybrid driv
Fig. 105 Center display: timer
131
OwnersManuals2.com