Audi Q5 2024 - Jump starting

Emergency assistance
» Mount the crank on the vehicle jack: insert the
crank into the opening on the handwheel. Turn
the crank to the left or right to secure it.
» Continue raising the vehicle jack with the crank
until the wheel lifts off the ground slightly.
ZX WARNING
To reduce the risk of injury, make sure no
one is in the vehicle before raising it.
— Make sure the vehicle jack is stable. The risk
of injury is increased when the ground is
slippery or soft, because the vehicle jack
could slide or sink.
= Only raise your vehicle with the vehicle jack
provided by the factory. If you use a vehicle
jack designed for another vehicle, your vehi-
cle could slip and cause injury.
= Position the vehicle jack only at the desig-
nated mounting points on the side sill and
align the jack. Otherwise, the vehicle jack
could slip and cause an injury if it does not
have sufficient hold on the vehicle.
=To reduce the risk of injury, do not raise any
other vehicles or other loads using the vehi-
cle jack provided by the factory.
— Applies to: vehicles with air suspension:
Changes in temperature or load can affect
the height of the stopped vehicle.
-To reduce the risk of an accident, never start
the engine when the vehicle is raised.
=To reduce the risk of injury, no work should
be performed under the vehicle while it is
raised.
Do not lift the vehicle by the sill. Position the
vehicle jack only at the designated mounting
points on the side sill. Otherwise, your vehicle
could be damaged.
306
Removing and installing a wheel
Fig. 193 Wheel: internal hex socket to turn the wheel
bolts
Fig. 194 Wheel: alignment pin in the top hole
Removing a wheel
» Remove the top wheel bolt completely using
the hex socket in the screwdriver handle from
the vehicle tool kit fig. 193 and place it ona
clean surface.
» Then install the alignment pin from the vehicle
tool kit in the empty wheel bolt hole by hand
© fig. 194.
» Remove the rest of the wheel bolts.
» Remove the wheel (2). The alignment pin re-
mains in the hole while doing this.
Installing a wheel
Read the directions on @ page 307 when instal-
ling unidirectional tires.
» Slide the wheel on over the alignment pin 2.
» Install the wheel bolts and tighten them gently
using the hex socket.
» Remove the alignment pin and tighten the re-
maining wheel bolt.
» Carefully lower the vehicle using the vehicle
jack".
» Tighten the wheel bolts in a diagonal pattern
using the wheel wrench*.
OwnersManuals2.com