Audi Q5 2024 - Fuses and bulbs; Fuses

8080127218H
Emergency assistance
~ If the power supply is interrupted, then it
will not be possible to move the selector
lever out of the "P” position. The parking
lock must be released using the manual re-
lease before towing the vehicle > page 104.
— Switch Audi pre sense* off > page 176 when
loading the vehicle onto a vehicle carrier,
train, ship, or other type of transportation,
or when towing the vehicle. This can prevent
an undesired intervention from the pre
sense* system.
— Follow the local legal regulations for tow-
ing.
Read and follow the important information un-
der
® page 310.
Preparations
» Only secure the towing cable or tow bar at the
designated towing loops > page 371,
page 312.
» Make sure the towing cable is not twisted. Oth-
erwise it could disconnect from the towing loop
while towing.
» Switch the emergency flashers on in both
vehicles @ page 55. However, do not do this if it
prohibited by law.
Towing vehicle (front)
» Only start to drive when the towing cable is
taut.
» Press the brake pedal very carefully.
» Avoid sudden braking or driving maneuvers.
Vehicle being towed (rear)
» Make sure the ignition is switched on so that
the steering wheel is not locked and so that you
can use the turn signals, the horn, and the
windshield wipers if needed > /\.
» Switching it off before the vehicle has stopped
may impair the function of the brake booster
and power steering. You would then need to
use more force to steer and brake the vehicle.
» Release the parking brake @ page 172.
» Select the “N” selector lever position.
» Make sure the towing cable is always taut.
— Never tow a vehicle using a tow bar or tow-
ing cable if the vehicle does not have electri-
cal power.
— If the vehicle loses power while it is being
towed, stop towing the vehicle immediately
and consult an authorized Audi dealer or
qualified repair facility.
Front to ig loop
The threaded opening for the towing loop is lo-
cated on the right side of the front bumper.
» Remove the towing loop from the vehicle tool
kit > page 302.
» Press the cap inward with brief, strong pressure
© fig. 197. The cap will loosen from the bump-
er.
» Tighten the towing eye as far as it will go into
the mount. Use a suitable object to tighten the
towing eye completely and securely in the
mount.
» After using, place the towing loop back in the
vehicle tool kit.
If the towing loop is not tightened all the way
when installing, the threads may be pulled
out when towing the vehicle and result in an
accident.
Depending on the model, the shape of the cap
can
vary.
311
OwnersManuals2.com