Audi Q5 2024 - Garage Door Opener

Opening and closing
= It is not possible to open the roof when tem-
peratures are too low.
Garage door opener
Applies to: vehicles with garage door opener
With the garage door opener, you can activate
systems such as the garage doors, security sys-
tems or house lights from inside your vehicle.
These functions are operated in the MMI. Multi-
ple receivers can be programmed, which can con-
trol the functions of up to eight! hand-held
transmitters.
When operating or programming the garage
door opener, make sure that no people or
objects are in the area immediately sur-
rounding the equipment. People can be in-
jured or property can be damaged if struck
when closing.
Do not allow yourself to be distracted from
traffic by viewing and operating the center
display.
— If you sell your vehicle, reset all settings to
the factory default settings = page 249.
~The system complies with United States FCC
regulations and ISED regulations
> page 328.
Before you program your system to the ga-
rage door opener, first check the compatibili-
—Ask an authorized Audi dealer or authorized
Audi Service Facility or check at www.
homelink.com. You can also find more infor-
mation about HomeLink there.
~ You can display information about Home-
Link (compatibility level/status/country
code/HomeLink generation) in the MMI:
1 The possible number of hand-held transmitters depends
on the equipment.
50
~Select on the home screen: VEHICLE > Set-
tings & Service > Garage opener > @.
Applies to: vehicles with garage door opener
Requirements: the remote control transmitter
must be programmed © page 51, Program-
ming, the vehicle must be within range of the
system, and the ignition must be switched on.
There are multiple options to open or close the
system (such as the garage door).
> To display the - button (Garage opener) for
the garage door opener, press the =] button in
the status bar © page 26.
» If you have only programmed one remote con-
trol transmitter, press the - button in the sta-
tus bar on the center display ® page 24. Or
» If you have programmed multiple remote con-
trol transmitters, press the 7 button in the
status bar on the center display > page 24 and
then press the button for the respective sys-
tem. Or
» Applies to: vehicles with programmable steer-
ing wheel button: If you have configured the
programmable steering wheel button, press
the > button © page 32. Or
» Applies to: vehicles with GPS pairing: If you
have programmed Location pairing, press the
respective button in the center display (notifi-
cation center & page 26). As you approach the
system, the button is displayed on the MMI. Or
> When reverse gear is selected, the parking sys-
tem* / rearview camera’ / peripheral camera*
will appear in the center display. To display the
buttons of the first three garage door openers,
press the [=] button in the status bar and then
press the button for the respective system.
If transmission was successful, the message:
Send to: XXX will appear.
OwnersManuals2.com