Audi Q5 2024 - Page 53

808012721BH
Opening and closing
Applies to: vehicles with garage door opener
You can program both fixed code and rolling code
systems in the MMI using the procedure that is
described.
Requirement: the ignition must be switched on.
Programming the system
Applies to: MMI
Requirement: the hand transmitter must be
present and the vehicle must be within range of
the system (such as the garage door) that you
would like to program. If you program more than
three remote control transmitters, assign the
first three spots to the systems that you would
also like to use when driving in reverse.
> To display the -@ button for the garage door
opener, press the [=I button in the status bar
© page 26.
> If you are programming the garage door opener
for the first time, press the ‘© button on the
center display. Follow the instructions in the
MMI. Or
» If you would like to program other systems, se-
lect on the home screen: VEHICLE > Settings &
Service > Garage opener. Select the desired
button: ©. Follow the instructions in the MMI.
> If you would like to reprogram systems that are
already programmed, select on the home
screen: VEHICLE > Settings & Service > Garage
opener. Press the Z button and select / for
the system to be reprogrammed. Select: Pro-
gram. Follow the instructions in the MMI.
With some systems, the garage door opener will
be immediately available after programming.
With other systems, the garage door opener
must also be synchronized.
Synchronizing”
Requirement: the hand transmitter must already
be programmed and the vehicle must be within
range of the system (such as the garage door).
1 Only applies to rolling code systems
If the system synchronization is performed di-
rectly after the programming procedure, follow
the instructions on the MMI.
If you would like to sync at a later time:
» Applies to: MMI: Select on the home screen:
VEHICLE > Settings & Service > Garage opener.
» Press the button for the system that you would
like to synchronize.
> Follow the instructions in the MMI.
Location pairing
Applies to: vehicles with location pairing
For easier operation, you can program your sys-
tem’s location.
Requirements: the respective hand transmitter
must be programmed © page 57 and the vehicle
must be located in front of the system.
» Ifyou have programmed your system, follow
the instructions in the MMI. Or
If you would like to set up location pairing at an-
other time:
» Applies to: MMI: Select on the home screen:
VEHICLE > Settings & Service > Garage opener.
> Press the Z button.
> Press the 7 button for the system your vehicle
is facing.
» Select: Location pairing.
» Follow the instructions in the MMI.
Only a maximum of three systems can be dis-
played in the notification center page 26. If you
would like to have all systems displayed, press
99
88.
Renaming programmed systems
You can rename the programmed systems ac-
cording to your preferences (names may have a
maximum of 10 characters)
> If you have programmed your system, follow
the instructions in the MMI. Or
If you would like to change the name at another
time:
» Applies to: MMI: Select on the home screen:
VEHICLE > Settings & Service > Garage opener. >
51
OwnersManuals2.com