Audi Q7 2007 - 15 - Cylinder Head, Valve Gear; Removing and Installing Cylinder Head; Cylinder Head - Exploded View of Components

Audi Q7 2007 !
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
Repair Group 15 – Cylinder head, valve gear
6
102
1 Removing and installing cylinder
head
Audi Q7 models with a 3.0 ltr. TDI engine are always
equipped with steel glow plugs.
1.1 Cylinder head - exploded view of compo-
nents
The diagram shows the cylinder head on cylinder bank 2 (left-
side).
1 - Cylinder head
" To prevent damage
to glow plugs, al-
ways place cylinder
head on a soft foam
surface after remov-
al.
" Removing
⇒ page 112
" Checking for distor-
tion ⇒ Fig. on
page 104
" Cylinder heads must
not be machined on
diesel engines
" Installing
⇒ page 114
" If renewed, refill
system with fresh
coolant
2 - Toothed belt drive
sprocket
" Use counterhold
tool -3036- when
loosening and tight-
ening central bolt
⇒ Fig. on page 103
" Remove using puller
-3032- ⇒ Fig. on
page 104
3- 75 Nm
" Use counterhold
tool -3036- when
loosening and tight-
ening ⇒ Fig.
4 - Oil seal for toothed belt sprocket for high-pressure pump
" Renewing ⇒ page 120
15 – Cylinder head, valve gear
Note
Note
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259