Audi Q7 2007 - Page 149

Audi Q7 2007 !
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
1 Removing and installing parts of lubrication system
143
6
Removing
– Remove sump (bottom section) ⇒ page 138.
– Detach baffle plate -arrows-.
– Unscrew bolts -1- and -2-.
– Hold oil pump drive shaft -3- firmly with long-nose grip pli-
ers -VAS 6226- and push shaft back against spring pres-
sure.
– Take out oil pump.
Oil pump drive shaft remains in position.
Installing
Installation is carried out in the reverse order; note the follow-
ing:
Renew seals and O-rings.
– Check that the two dowel sleeves are fitted in the oil
pump; install if necessary.
– Install sump (bottom section) ⇒ page 141.
– Fill up with engine oil and check oil level ⇒ page 157.
Tightening torques
Component Nm
Oil pump to sump (top section) 23
Baffle plate to sump (top section) 9
Note
Note
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259