Audi Q7 2007 - 6.3 Wheel Hub and Wheel Bearing, Removing and Installing

Audi Q7 2007 !
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
Repair Group 19 – Cooling
6
166
– Unscrew bleeder screw -arrow- at front of engine.
– Fill up with coolant until it comes out at bleeder hole with
no air bubbles.
– Close the bleeder screw.
– On vehicles with auxiliary heater, switch heater on (for
about 30 seconds) and then off again.
– Tighten filler cap on expansion tank.
– Start engine.
– Set heater/air conditioner (front and rear) to “HI”.
– Run the engine for 3 minutes at 2000 rpm.
– Allow the engine to run at idling speed until the two large
coolant hoses at main radiator become warm.
– Run the engine for 1 minute at 2000 rpm.
– Switch off ignition and allow to cool down.
– Check coolant level.
• The coolant level must be at the MAX marking -arrow-
when the engine is cold.
• The coolant level can be above the MAX marking when the
engine is warm.
Tightening torque
Component Nm
Bleeder screw to coolant pipe 8
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259