Audi Q7 2007 - Page 66

Audi Q7 2007 !
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
Repair Group 13 – Crankshaft group
6
60
– Remove bolts -1 … 9- and detach timing chain cover (bot-
tom).
– Press out crankshaft oil seal (timing chain end) from the
timing chain cover (bottom).
Installing
Renew gaskets, seals and O-rings.
– Remove old sealant from grooves in timing chain covers
and from sealing surfaces.
– Remove remaining sealant on timing chain covers and cyl-
inder block / cylinder head using rotating plastic brush or
similar.
– Clean sealing surfaces; they must be free of oil and grease.
– Cut off tube nozzle at front marking (nozzle approx. 1.5
mm ∅).
♦ The sealant beads must not be thicker than specified, oth-
erwise excess sealant could enter the sump and clog the
strainer in the oil pump.
♦ The timing chain covers must be installed within 5 minutes
after applying sealant.
WARNING!
Wear safety goggles.
Note
Note
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259