Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– If necessary, the support -arrow- with the »small« interior di‐
ameter must be removed from the Hydraulic Press - VAS6178-
and the Pressure Head - T10205/13- for that installed.
– Place the tools on the front bonded rubber bushing as shown
in the illustration.
1 - Thrust Piece - T10301/5-
2 - Support Ring - T10301/4- . The chamfer on the exterior di‐
ameter must face toward the subframe.
3 - Tube - T10301/3-
4 - Hydraulic Press - VAS6178-
5 - Washer - T10205/4-
6 - Nut - T10301/2-
7 - Spindle - T10301/1-
– Place the tools on the rear bonded rubber bushing as shown
in the illustration.
1 - Thrust Piece - T10301/5-
2 - Support Ring - T10301/4- . The chamfer on the exterior di‐
ameter must face toward the subframe.
3 - Tube - T10301/3-
4 - Hydraulic Press - VAS6178-
5 - Washer - T10205/4-
6 - Nut - T10301/2-
7 - Spindle - T10301/1-
WARNING
♦ Secure Hydraulic Press - VAS6178- while pressing out.
♦ Bonded rubber bushing loosens »abruptly«. There is the
risk of injuries by tools and bonded rubber bushing coming
off!
– Place Shop Crane - Drip Tray - VAS6208- underneath.
– Press out bonded rubber bushing and collect escaping oil.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
2. Subframe, Stabilizer Bar, Coupling Rod and Stone Deflector 131
To Next Page
Loading...
