Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove boot from collar on shock absorber -arrow- and re‐
move it from shock absorber.
– If shock absorber is replaced, then cover cap -1- and nut
-arrow- must be removed and then installed on the new shock
absorber.
Suspension Strut (Air Suspension), Installing
– If shock absorber was not replaced, gasket must be replaced
-arrow-.
– Clean contact surfaces with a lint-free cloth.
Note
Even the smallest contaminants lead to air spring leakage.
– Lightly grease ring with Lithium Grease .
– Position boot -2- on shock absorber.
– Slide stop buffer -1- with smaller diameter down onto shock
absorber.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
156 Rep. Gr.42 - Rear Suspension
To Next Page
Loading...
