Audi Q7 2007 - 6.4 Bonded Rubber Bushing, Removing and Installing

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
❑ Suspension strut (coil spring), Removing and Installing, refer to
⇒ “5.2 Coil Spring Suspension Strut, Removing and Installing”, page 162 .
9 - Bonded Rubber Bushing
❑ Replace, refer to ⇒ “6.4 Bonded Rubber Bushing, Removing and Installing”, page 177 .
10 - Tie Rod
❑ Removing and Installing, refer to ⇒ “3.6 Tie Rod, Removing and Installing”, page 143 .
11 - Upper Rear Control Arm
❑ Removing and Installing, refer to ⇒ “3.5 Upper Rear Control Arm, Removing and Installing”, page 142 .
12 - Right Rear ABS Wheel Speed Sensor - G44- and Left Rear ABS Wheel Speed Sensor - G46-
❑ Removing and Installing, refer to ⇒ Rep. Gr. 45 .
13 - Bolt
❑ 8 Nm
14 - Lower Control Arm
❑ Removing and Installing, refer to ⇒ “3.2 Lower Control Arm, Removing and Installing”, page 140 .
15 - Wheel Bearing
Caution
•Avoid contaminating with
dirt and damaging the
seal when setting down/
storing, refer to
⇒ Fig. ““Avoid contami‐
nating with dirt and dam‐
aging the seal when set‐
ting down/storing.”“ ,
page 170 .
❑ Note installed position, refer to ⇒ page 176 .
❑ Removing and Installing, refer to
⇒ “6.3 Wheel Hub and Wheel Bearing, Removing and Installing”, page 172 .
16 - Locking Ring
❑ Check for proper seating.
❑ Opening must face downward.
17 - Wheel Hub
❑ Removing and Installing, refer to
⇒ “6.3 Wheel Hub and Wheel Bearing, Removing and Installing”, page 172 .
18 - Self-Locking Nut
❑ 500 Nm
❑ Always replace if removed.
❑ before assembling, coat contact surface with Assembly Paste .
19 - Bolt
❑ 20 Nm
20 - Bolt
❑ 8 Nm
21 - Cover Plate
22 - Wheel Bearing Housing
❑ Removing and Installing, refer to ⇒ “6.2 Wheel Bearing Housing, Removing and Installing”, page 170 .
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
6. Wheel Bearing Housing, Wheel Hub and Wheel Bearing 169