Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Mount tools as depicted in illustration.
Note
Offset of thrust piece - T10205/6- must point toward rear final
drive.
1 - Threaded Rod M20 - T10205/8-1-
2 - M20 Nut - T10205/8-2-
3 - Hydraulic Press - VAS6178-
4 - Thrust Piece - T10205/10-
5 - Threaded Rod M20 - T10205/8-1-
6 - M20 Nut - T10205/8-2-
7 - Thrust plate - T10205/6-
– Connect Pneumatic/Hydraulic Foot Pump - Pressure Gauge -
VAS6179/1- between Hydraulic Press - VAS6178- and hy‐
draulic line of Hydraulic Press - VAS6178- .
Pressures, described in the following, apply only to the Hydraulic
Press - VAS6178- .
While pressing in, pressure reading must be between 30 and 100
bar shortly before end of pressing in.
Maximum pressure must not exceed 140 bar.
– Press in wheel hub until stop.
– Install the drive axle, refer to
⇒ “7.3 Drive Axle, Bolted Inner Joint, Removing and Installing”,
page 182 .
Install in reverse order of removal.
– Install Rear Speed Sensor -4-, refer to ⇒ Rep. Gr. 45 .
– Assemble brakes ⇒ Rep. Gr. 46 .
– Install bracket -1- and wiring harness. Tighten the bolt -2- to 8
Nm.
6.4 Bonded Rubber Bushing, Removing
and Installing
Special tools and workshop equipment required
♦ Engine/Gearbox Jack - VAG1383A-
♦ Hydraulic Press - Bushing Assembly Tool Kit - T10230-
♦ Hydraulic Press - VAS6178-
♦ Engine/Gearbox Jack Adapter - Wheel Hub Support - T10149-
♦ Pneumatic/Hydraulic Foot Pump - VAS6179-
♦ Torque Wrench 1332 40-200Nm - VAG1332-
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
6. Wheel Bearing Housing, Wheel Hub and Wheel Bearing 177
To Next Page
Loading...
