Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Disconnect the wire -3- from the bracket on the wheel bearing
housing.
– Remove the threaded connection -4- and -5- from the cable
bracket.
– Disconnect the connector from the brake pad wear display.
– Move the wiring harness to the side.
– Turn the wheel hub until one of the holes for the wheel bolts
is on the bottom.
– Set up the tools as shown in the figure.
1 - Drive Axle Remover - Adapter Plate - T10103/1-
2 - Drive Axle Remover - T10103-
3 - Engine/Gearbox Jack Adapter - Wheel Hub Support -
T10149-
4 - Engine/Gearbox Jack - VAG1383A-
– Support the wheel bearing housing.
– Loosen the threaded connection -1- between the suspension
strut and the coupling rod at the wheel bearing housing.
– Separate the threaded connection -2- between the tie rod and
the wheel bearing housing.
– Loosen the threaded connection -5- on the lower transverse
link.
– Remove the threaded connection -3- on the upper rear trans‐
verse link.
– Remove the threaded connection -4- on the upper front trans‐
verse link.
– Unclip the brake cable from the subframe and free it up.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
7. Drive Axle 187
To Next Page
Loading...
