Audi Q7 2007 - Page 339

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Applies to Engine, Generation I with SCR and Generation II
– Loosen the air guide pipe -4- (if equipped) in the center and
move it upward. Remove the screw -1- and -2- and loosen the
screw -3-, refer to ⇒ Rep. Gr. 21 .
Note
Be sure not to damage any parts when moving the air guide pipe
-4-.
Applies to All
– Mark ribbed belt running direction
– Release the tension on the ribbed belt and remove it from the
power steering pump belt pulley ⇒ Rep. Gr. 13 .
– Remove bolts -arrows-. Counterhold belt pulley with Wrench -
Pin Type - 3212- when doing so.
Applies to Engine, Generation I without SCR
– Lay several cloths under the power steering pump and hy‐
draulic pipes.
– Clamp the intake hose using Hose Clamps - Up To 25mm -
3094- and remove from power steering pump.
– Remove banjo bolt -1-.
– Remove screws -1-.
– Remove the screw -2- and remove the power steering pump
-3-.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
5. Power Steering Pump, Hydraulic Pipes and Reservoir 331