Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Start engine and when at idle speed, close shut-off valve
-item 1- and read pressure (do not measure longer than 10
seconds).
Delivery pressure specified value: 110 to 128 bar
If specified value is not obtained, replace power steering pump
⇒ “7.4 Power Steering Pump, Removing and Installing, Vehicles
with V8 TDI Engine”, page 357 .
– Switch off engine.
– Remove Power Steering Test Unit - VAG1402- .
– Install the banjo bolt with new gaskets, refer to -Item 13-
⇒ Item 13 (page 358) . Note location of pressure line when
doing so, refer to
⇒ Fig. ““Pressure line location on power steering pump”“ , page
359 .
– Bleed steering system, refer to
⇒ “4.2 Steering System, Bleeding after Replacing”,
page 311 .
– Check power steering fluid level, refer to
⇒ “4.1 Power Steering, Checking Hydraulic Oil Level”,
page 310 .
– Check the steering system for leaks, refer to
⇒ “4.3 Steering System, Checking for Leaks”, page 312 .
– Install noise insulation, refer to ⇒ Rep. Gr. 50 .
– On vehicles with air suspension, position vehicle on wheels,
refer to
⇒ “4 Positioning Vehicle on Hoist and Wheels”, page 10 .
7.4 Power Steering Pump, Removing and
Installing, Vehicles with V8 TDI Engine
Power steering pump, assembly overview:
Note
♦
Always replace seals.
♦
Do not reuse fluid you have drained.
♦
Only use Hydraulic Oil .
♦
When replacing the power steering pump, replace its seal and o-ring ⇒ Rep. Gr. 15 .
♦
Only use Grease Parts Catalog to lubricate.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
7. Power Steering Pump, Hydraulic Pipes and Reservoir, Vehicles with V8 TDI Engine 357
To Next Page
Loading...
