Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove the screws -5 and 10- and nut -6-.
– Move the fuel filter -9- with the fuel hoses still connected
-1, 2, 3 and 8- to the side.
Note
Ignore -4 and 7-.
Caution
Danger of causing damage to the check valve.
♦ Do not secure the Hose Clamps - Up To 25mm - 3094- on
the return hose near the check valve. Otherwise, check
valve will be damaged.
♦ The check valve is in the return hose between the cambers
-A arrows- or between hose clamps -B arrows-.
– Clamp off the return line -1- and the intake line -2- on the res‐
ervoir with Hose Clamps - Up To 25mm - 3094- .
Note
Place a cloth under the separation point to catch any hydraulic
fluid dripping out.
– Remove the banjo bolt -1-.
Note
Ignore -2-.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
9. Power Steering Pump, Hydraulic Pipes and Reservoir, Vehicles with V12 TDI Engine 385
To Next Page
Loading...
