Audi Q7 e-tron quattro 4M - Emergency Release, Parking Lock

27
1
2
3
Emergency release, parking lock
649_061
649_062
649_063
Emergency release Bowden
cable 1
Emergency release Bowden
cable 2
Locking sleeve
Quick-connect coupling
Quick-connect coupling
Reference
For more information about the parking lock emergency release device in the AudiQ7e-tronquattro, refer to Self Study
Programme632 "Audi Q7 (type 4M)", page 48 .
The emergency release device of the parking lock in the
AudiQ7e-tronquattro is identical to the emergency release device
of the AudiQ7 (type4M), as described in SSP632, page 48 .
If it is necessary to hold the parking lock in the P-OFF position for
longer, the emergency release device serves to release the parking
lock and should be actuated in the following situations:
• To tow the vehicle
• If the parking lock cannot be released electro-hydraulically due
to a malfunction.
• If the vehicle cannot be manoeuvred or moved due to insuf-
ficient onboard voltage.
• If the engine is not running and it is necessary to manoeuvre or
move the vehicle, e.g. in the workshop.
If it is no longer necessary to hold the parking lock in the P-OFF
position, it should be released again and moved back into the P-ON
position.
It is necessary to check the emergency release device after assem-
bly work on its component parts.
Warning!
Before actuating the emergency release device of the parking
lock, the vehicle must be secured to prevent it from rolling away.
Emergency-releasing the parking lock (P-OFF position)
• Remove cover.
• Insert the socket wrench insert for emergency release into the
actuating mechanism as shown under position 1 in Fig.
649_061.
• Push down the socket wrench insert and turn it clockwise
through 90° until the socket wrench insert noticeably engages
the actuating mechanism (position2 in Fig. 649_061).
When the parking lock emergency release device is
actuated, the yellow gearbox warning lamp and the
gear drive position indicatorN light up in the instru-
ment cluster.
The following message is also displayed in the instru-
ment cluster: "Vehicle may roll away! P cannot be
selected. Please apply parking brake."
Locking the parking lock (P-ON position)
• Simply pull the socket wrench insert upwards out of the actuat-
ing mechanism (position3 in Fig. 649_062).
Note:
The socket wrench insert must not be turned back, as this will
damage the actuating mechanism of the emergency release
device.
• Fit the cover.
Quick-connect coupling
To simplify removing and installing the gearbox, the emergency-
release Bowden cable consists of two parts, which are intercon-
nected by a quick-release coupling. Refer to Workshop Manual.
Socket wrench
Actuating mechanism
ProCarManuals.com
< Back
Forward >
Ξ Contents