Audi Q7 e-tron quattro 4M - Plug-in Hybrid Drive Components

28
Plug-in hybrid drive
The internal combustion engine and the eight-speed automatic
gearbox 0D7 with hybrid module are key components of the hybrid
drive.
To separate the hybrid module from the basic gearbox, the screw
coupling between the transmission plate of the torque converter
and the end plate of the separation clutch K0 must be discon-
nected via the service port.
There are 5 tangential oblong holes and 1 radial oblong hole in the
torque converter transmission plate.
To assemble the hybrid module, the first screw must be inserted
into the radial oblong hole and tightened. This is followed by the
screws for the tangential oblong holes.
649_064
Screw coupling position1,
radial oblong hole
Service port cover
Cover/service port
Flanged shaft, front left
Torque converter
Gasket
Tangential oblong hole Torque converter
transmission plate
End plate of separation clutch K0
Basic gearbox
Rear gasket ring
of the protection tube
ProCarManuals.com
< Back
Forward >
Ξ Contents