Audi Q8 e-tron 2024 - Charging Settings

4K4012721BA
High-voltage system
» End the charging process > page 118.
» Open the hood © page 254.
> Open the cover in the front compartment on
the side with the affected charging port.
» Loosen the yellow loop @) © fig. 87 from the
retainer and then pull on the loop carefully
2.
» Remove the charging connector.
» After releasing manually, secure the loop on
the retainer and close the cover.
» Drive to an authorized Audi dealer or author-
ized Audi Service Facility immediately to have
the malfunction corrected.
If the charging connector still cannot be removed
after using the manual release, there is still a
malfunction. The charging connector could also
be frozen in place if the temperatures are below
freezing. See an authorized Audi dealer or au-
thorized Audi Service Facility for assistance in any
case.
© Note
Only pull on the loop until you feel resistance.
You will not hear it release. If you continue to
pull, you could damage the manual release
mechanism.
The following messages may appear depending
on the vehicle equipment:
if the 3] or fi indicator light turns on, then the
range is low or very low. Charge the high-voltage
battery.
Vehicle charging connection: malfunction! See
owner's manual
This message appears if the charging port door is
‘open while driving. Stop the vehicle as soon as
possible and try to close the charging port door
page 117, fig. 85. If the charging port door
cannot close and/or the message continues to
appear, drive to an authorized Audi dealer or au-
thorized Audi Service Facility immediately and
have the malfunction corrected > A\ in Charging
on page 118; &@ in Charging on page 119.
Connector lock: malfunction! See owner's man-
ual
This message appears if the charging connector
could not be locked correctly in the charging
port. Disconnect the charging connector, insert it
in the charging port again, and press upward on
it lightly for approximately 5 seconds. You can al-
so use another charging station if available. If the
message still appears, see an authorized Audi
dealer or authorized Audi Service Facility for as-
sistance.
Ei charg. syst.: malfunction
This message appears if there is a malfunction in
the vehicle charging infrastructure or the charg-
ing station. Use a different charging station if
possible. If this message does not turn off, con-
tact an authorized Audi dealer or authorized Audi
Service Facility.
Charging settings
Fig. 88 Upper display: charging settings
Depending on the vehicle equipment, you may be
able to adjust individual charging settings.
— Applies to: MMI: Select on the home screen:
VEHICLE > Charging.
~ You may need to scroll to the display © fig. 88.
@® Display of the current charging target or bat-
tery charge level
@ Seta charging target
@® Open additional settings
@ Switch timer charging mode on or off
Charging mode
When immediate charging mode is selected, the
charging process will start immediately after the
charging connector has been plugged in and the >
121
OwnersManuals2.com