Audi Q8 e-tron 2024 - Cooling System

4K4012721BA
Checking and Filling
be burned. Wait until no steam or coolant is
escaping.
—For safety reasons, the hood must always be
latched securely while driving. Because of
this, always check the hood after closing it
to make sure it is latched correctly. If the
front corners of the hood cannot be lifted,
then the lid is latched correctly.
~ If you notice that the hood is not latched
while you are driving, stop immediately and
close it, because driving when the hood is.
not latched increases the risk of an accident.
| Front compartment overvie
The most important check points.
Fig. 162 Overvi
Observe the safety precautions © page 253, Gen-
eral information.
@ Washer fluid reservoir (€) page 267
@® Coolant expansion tank (i) under a cover
page 256
@ Brake fluid reservoir (Q)) under a cover
© page 257
Cooling system
E
Observe the safety precautions © page 253, Gen-
eral information.
The cooling system is filled with a mixture of pu-
rified water and coolant additive at the factory.
This coolant must not be not changed.
The coolant level is monitored using th
cator light. However, you should occasionally
check the coolant level.
Messages
The following messages may appear depending
on the vehicle equipment:
Turn off engine and check coolant level. See
owner's manual
The coolant level is too low.
255
OwnersManuals2.com