Audi Q8 e-tron 2024 - Page 296

Emergency assistance
— Please note that the tire mobility kit cannot
be used in all situations, and that it may on-
ly be used temporarily.
- The tire sealant must not come in contact.
with skin, eyes, or clothing.
— If tire sealant comes into contact with your
eyes or your skin, thoroughly rinse the af-
fected area immediately with clean water.
—Do not inhale the fumes.
— If you swallow any of the tire sealant, thor-
oughly rinse your mouth immediately and
drink a lot of water. Do not induce vomiting.
Seek medical attention immediately.
~Change your clothing immediately if it
comes into contact with tire sealant.
—If an allergic reaction occurs, seek medical
attention immediately.
—Keep the tire sealant away from children.
— In vehicles with a tire pressure monitoring
system”, using tire sealant can result in an
incorrect display or a system malfunction.
Drive carefully to the nearest authorized
‘Audi dealer or authorized Audi Service Facili-
ty.
OH Batteries and electrical/electronic devices
must be disposed of in an environmentally
safe manner > page 378, Disposal instruc-
tions.
~ If sealant leaks, allow it to dry in place. You
can then peel it off like a sticker.
— Note the expiration date on the sealant bot-
tle. Replace the tire sealant at an author-
ized Audi dealer or authorized Audi Service
Facility.
— Radio reception can be interrupted when
operating the compressor.
— Follow the legal regulations that are appli-
cable in the country where you are operat
ing the vehicle.
1) The compressor may look different. However, the way itis
operated is generally the same.
294
Applies to: vehicles with tire mobility kit
Pen
Geo!
Fig. 172 Components of the tire mobility kit
Fig. 173 Tire mobility kit connection
Requirement: the tire mobility kit must be laid
out and ready for use page 293.
Setting up the tire mobility kit
» Remove the connector @) and pressure hose @)
from the bottom of the housing.
» Connect the compressor pressure hose @) ") to
the flange © on the tire sealant bottle @.
» Insert the sealant bottle with the flange at the
bottom into the opening @) on the compressor.
» Remove the valve cap from the faulty tire.
» Connect the filler hose @ to the valve ©)
© fig. 173.
> Connect the plug @ © fig. 172 to an outlet in
the vehicle.
> Switch the ignition on.
Inflating a tire
» Move the switch @ © fig. 173 on the compres-
sor into position I.
OwnersManuals2.com