Audi Q8 e-tron 2024 - Page 304

Emergency assistance
towing
eye
completely
and
securely
in
the
Vehicles
with
a
factory-installed
trailer
hitch*
are
mount.
not
equipped
with
towing
loop
threads
at
the
» After
using,
place
the
towing
loop
back
in
the
rear.
vehicle
tool
kit.
If the towing loop is not tightened until it
stops when installing, the threads may be
pulled out when towing the vehicle and result
in an accident.
If the towing loop is not tightened until it
stops when installing, the threads may be
pulled out when towing the vehicle and result
— (Oe
Depending on the model, the shape of the cap hitch*, only use suitable tow bars that are
can vary. compatible with it. If a tow bar is not availa-
ble, you can use a towing cable.
—
Ow
Depending on the model, the shape of the cap
can
vary.
Fig. 182 Rear bumper: installing the towing loop
Vehicles with a towing loop
On vehicles without a factory-installed trailer
hitch*, the towing loop threads are located on
the right rear side of the bumper.
» Remove the towing loop from the vehicle tool
kit @ page 293.
» Press the cap inward with brief, strong pressure
® fig. 182. The cap will loosen from the bump-
er.
» Tighten the towing eye as far as it will go into
the mount. Use a suitable object to tighten the
towing eye completely and securely in the
mount.
» After using, place the towing loop back in the
vehicle tool kit.
Vehicles with a trailer hitch*
» Attach the tow bar or the towing cable to the
trailer hitch.
302
OwnersManuals2.com