EasyManua.ls Logo

Audi R8 2009 - Clear vision; Exterior Lights Control

Audi R8 2009
276 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Cl e ar vision
Clear vision
Lights
Switching the headlights on and off ·'t!.·
IR~t 9
Fig. 42 Instrum ent
panel: light sw itch
Switching on the side marker lights
Tur n t he lig ht swi t ch ligh t to ;oo;. The indi cator lig ht ;oo;
com es on .
Switching on th e headlights and high beam
Turn t he light switch to ~D.
Push the high beam lever for w ard towa rds the instru-
ment panel
=> page 58.
Switching off the lights
- Tur n the lig ht switch to 0.
The headlights on ly work when the ignition is switched on. Whi le
starting the engine or when switching off the ignition, the head -
lights will go off and on ly the side marker lights wi ll rema in lit.
If the rotary light switch is in the
O or AUTO position, the daytime
running lights are turned on when the ignition is switched on if they
were activated via the menu display => page 26.
& WARNING
Crashes can happen w hen you cannot see the road ahead and
when you cannot be seen by other motor ists.
Alway s turn on the headlight s so that you can see ahead and
so that others can see your car from the back.
Never use daytime running light s to see whe re you are going.
They are not bright enough and will not let you see far enough
ahead for safety, especially at dusk or when it is dark . Be aware of
changes in outside light condit ions when you are driving and
respond by switching on your low beams
~D.
[ i ] Tips
If you remove the ignition from the ignition lock while the head -
lights are still on, a buzzer will sound as long as the driver's door is
open to remind you to switch off the lights .
Always observe the specific local regulations for your area when
to use your lights .
In cool or damp weather conditio ns the headlights may fog over
temporar ily on the inside .
- The critical fac tor is the temperature difference between t he
interior and the exterior of the headlight lens.
- With the main beams switched on, the light -emitting area will
be free of condensation after a short time, however the edges of
the glass may st ill be fogged.
- This physica l phenomenon has no effect on the life of your
veh icle's lighting system .
~

Table of Contents

Related product manuals