HomeLin k®
9 . The emergency flashers will flash thr ee tim es (after about
15-60 seconds) when the programming is successful.
Release the button on the remote control.
- To program more devices, repeat steps 4 to 9.
10. Press and hold the trained Homelink ® button and
observe the indicator light © =>
page 97, fig. 81 .
- If the indicator light is solid/continuous, programming is
complete and your device should activate when you press
and release the trained Homelink ® button.
- If the indicator light blinks rapidly for 2 seconds and is
then a solid/continuous light, proceed with phase 3 to
program a rolling code device.
Phas e 3 : rolling cod e programming
- A second person on a ladder who can safely reach t he
garage door opener motor is recommended.
11. Locate the "learn" button on the garage door opener
motor (refer to the operating instructions for the opener,
as the location of this button may vary by manufac t urer) .
12. Press and release the learn button on the garage door
opener motor .
- Not e: once the button is pressed, there are 30 seconds in
which to initiate the next step.
13. On the Homelink ® keypad inside the vehicle, firmly press
and hold the Homelink ® button previously programmed
in phases 1 and 2 for two seconds and release. Repeat this
sequence
twice .
- Some vehicles may require the press/hold/release
sequence up to three times to complete the training
process.
- Homelink ® should now activate your rolling code
equipped device.
If the 5 minute time limit is exceeded, the emerge ncy flashers will
flash one ti me
to indicate that the process has been terminated. In
this case, repeat steps 4 th rough 9.
If the emergency flashers do not flash
three times (after about 15 -
60 seconds), p rogramming was not success ful. In this case, repeat
steps 4 through 9.
Remote control units for garage door openers in Canada are set to
stop transmitting radio frequency signals after two seconds. This
time may not be sufficient for the Homelink ® system to learn the
radio frequency signal. Perform all other steps as descr ibed above. •
Applies to vehicles : with Hom elink ® un iversal remote contro l
Operating the Homelink ® transmitter
The HomeLink ® transmitter works in the same manner as
the original handheld remote control that came with the
system.
Fig. 83 Overhead
console: Homelink ®
keypad
To Next Page
Loading...
