On the road
You can also increase your speed by pressing the accelerator pedal.
After you re lease the accelerator pedal, the system automat ically
adjusts back down to the speed you previously set.
However, if you exceed this speed by 5 mph (10 km/h) for longer than
5 minutes, the stored speed will be deleted. You will have to resave it.
Briefly pressing lever
The desired speed is increased by about 2 mph (2 km/h) by br iefly
pressing the lever upwards towards ~ fig.
65 G).
The desired speed is decreased by about 2 mph (2 km/h) by br iefly
pressing the lever downwards towards ~ fig .
65 G). •
Switching control mode off temporarily
- Step on the brake pedal, or
- Depress the clutch pedal all the way, or
- Press the lever towards
0 (not latched) =:> page 81,
fig. 65.
When the system is turned off temporarily, the speed stored at the
time is retained.
To resume the stored speed, release the brake or clutch pedal and
pull the lever to position
(D.
If no desired speed was stored when the system was temporarily
switched off, you can store a new desired speed as follows : Drive at
the desired speed and briefly press button~
page 81, fig. 65 @
(SET).
& WARNING
You should only return to the saved speed if it is not too fast for
the current traffic conditions - risk of an accident! •
Deactivating
- Press lever into position 0 (latched) =:> page 81, fig . 65.
The saved speed value is de let ed when the ignition is switched off .
[I) Tips
Switch the cru ise control system off completely at the end of each
trip. When you start the next trip, the desired speed can be set simply
from the basic setting=!>
page 81. •
Audi magnetic ride
Damping can be adjusted to the driver's preference and it
adapts automatically to the current driving situation.
Fig. 66 Center
console: Switch for
Audi magnetic ride
- Press the switch =:> fig. 66 to turn sport setting on or off.
Audi magnetic ride is an electronically controlled damping system.
This chassis system ass ists the driver by adapt ing to the pa rticular
situation through imperceptible control processes. The
damp ing
prov ides individual modulat ion of damping forces . For example, with
damping characteristics set to provide greater comfort, damping is
1))-
To Next Page
Loading...
