Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Start program by selecting Carry out check .
– Continue to follow instructions on screen.
Note
♦
The transport mode serves to maintain the vehicle's ability to
start.
♦
When the vehicle is in transport mode, many functions, e.g.
radio, are restricted or unavailable.
3.4 Transport mode: checking activation
and activating if necessary
Checking transport mode ⇒ page 13
Activating transport mode ⇒ page 13
3.4.1 Checking transport mode
Procedure:
– Switch on ignition.
– Check whether »Transport mode on« is shown in instrument
cluster.
– If necessary, activate transport mode ⇒ page 13 .
3.4.2 Activating transport mode
Procedure:
– Connect vehicle diagnostic tester ⇒ page 6 .
– Select Diagnosis mode and begin diagnosis.
– Perform vehicle identification.
– De-select “Working with Guided Fault Finding” by removing
v and press Apply .
– Switch to “Special functions” tab and select following program:
♦ 19 - Activating / deactivating transport mode
– Start program by selecting Carry out check .
– Continue to follow instructions on screen.
Note
♦
The transport mode serves to maintain the vehicle's ability to
start.
♦
When the vehicle is in transport mode, many functions, e.g.
radio, are restricted or unavailable.
3.5 Battery: reading out status and sending
diagnostic log
This maintenance item only applies to certain model years: Note
specification in Maintenance table.
Procedure:
– Connect vehicle diagnostic tester ⇒ page 6 .
Audi R8 2015 ➤
Maintenance - Edition 03.2016
3. Maintenance 13
To Next Page
Loading...
