Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Procedure for connecting battery charger:
– Remove cover for brake fluid reservoir in luggage compart‐
ment.
– Disconnect charger clamps from battery charger - VAS 5906- .
– Thread connector end of cables for charger clamps through
hole at brake fluid reservoir to wheel housing.
– Open battery terminal cover -1-.
– First connect charger clamp (+) to positive battery terminal
-3-.
– Then connect charger clamp (-) to jump start terminal (-) -2-.
– Arrange wiring of battery charger - VAS 5906- neatly in recess
in bottom of luggage compartment.
– Under vehicle: Connect cable for charger clamps to battery
charger - VAS 5906- .
– Switch on battery charger - VAS 5906- and adjust settings as
needed.
– Position battery charger - VAS 5906- under vehicle so that it
is hidden from view as well as possible, ensuring that ventila‐
tion grille of charger is unobstructed.
Procedure for disconnecting battery charger:
Remove in reverse sequence.
3.9 Battery: determining and recording state
of charge (SOC)
Vehicles with transport mode ON ⇒ page 18
Vehicles with transport mode OFF ⇒ page 19
3.9.1 Vehicles with transport mode ON
Procedure:
– Read off battery charge level on instrument cluster.
– Use results of test to determine following measures:
Audi R8 2015 ➤
Maintenance - Edition 03.2016
18 3. Maintenance
To Next Page
Loading...
