901- Engine Warm-Up Procedure / Engine Start
Version 1 2016-01-01 101 / 113
901 - 1.3 Checking Gearbox Oil Level
See chapter 300 – Gearbox, Drive Shafts and Ancillary Components for
information about gearbox oil quality and fill level.
Checking gearbox oil level
1. Position the car on a level, flat surface.
2. To measure the oil level, remove the oil dipstick, wipe dry with a
clean cloth. Afterwards, screw the oil dipstick by hand to the final
position, then remove and check the oil level.
3. After the warming up procedure (tgear – 60°C), the oil level should
be immediately below the ‘MAX’ mark on the oil dipstick.
Attention
If the oil level is too high and / or the car is driven when the gearbox oil
temperature is too low, it is possible that a significant amount of oil will be
discharged from the gearbox breather!
Image 40: Gearbox – Clutch Bleed Nipple, Oil Level Check, Inspection Openings
To Next Page
Loading...
