100 – Engine Ancillaries, Oil Tank and Water Cooler
Version 1 2016-01-01 28 / 113
- Tighten the expansion reservoir cap
The cap must click audibly and noticeably into position when
closing.
- Only check the coolant level when the engine is cold.
When the engine is cold, the coolant must be level with the ‘MAX’
mark.
When the engine is at operating temperature, the coolant level can
be above the ‘MAX’ mark.
Image 3: Expansion Reservoir
If air is still in the system after bleeding, it is recommended that the bleed
nipple on the water cooler is opened with the engine at normal operating
temperature until coolant escapes from the bleed nipple. This procedure should
be repeated until only coolant escapes after the bleed nipple is opened.
To Next Page
Loading...
