100 – Engine Ancillaries, Oil Tank and Water Cooler
Version 1 2016-01-01 29 / 113
100 - 1.3 Clutch - Flywheel
a) Service and Maintenance
Please refer to PDM 4SA 141 000 for 902 – Service and Maintenance Contacts.
b) Bleeding
1. Attach an empty bleed bottle hose to the clutch bleed nipple
2. Fill the reservoir on the clutch actuator half-full with brake fluid
(spec DOT 3, DOT 4, DOT 4+ (plus), super DOT 4+ (plus), DOT 5.1)
3. Minimum ½ litre extra brake fluid available
4. Open the bleed nipple
5. Pull and release the clutch paddle while adding brake fluid to the
reservoir
6. When no more air escapes from the bleed nipple and after at least
½ litre of brake fluid has been added, pull and hold the clutch
paddle
7. Tighten the bleed nipple
8. Pull the paddle to check the clutch pressure (value should be
between 23 and 28 bar)
To Next Page
Loading...
