400 – Front Axle, Anti-Roll Bar, Dampers and Steering
Version 1 2016-01-01 49 / 113
400 – 2.4 Damper / Ride Height Adjustment
Bump Stops and Packers
The following packers are available:
To install bump stops and packers, the push rod (part with external hex) must
be removed from the piston rod. Procedure as follows:
1. Clean the piston rod thoroughly with iso-propanol
2. Clamp the piston rod using aluminium clamp blocks V03 862 342
AB (Öhlins part number 00727-05, sold in pairs)
3. Before removing the push rod, heat it with a hot air gun.
First mount the bump stops (material: foam) on the side of the damper body. A
full packer should always be mounted between the bump stops and the slotted
packers (material: POM, polyoxymethylene).
To refit the push rod, the threads on the piston rod must be cleaned, apply
Loctite 270 and tighten the push rod to 60 Nm torque.
Damper lengths and static ride height adjustment
To Next Page
Loading...
