Audi R8 LMS 2018 - Front Axle Spring Platform Adjustment; Rear Axle Spring Platform Adjustment

400 – Front Axle, Anti-Roll Bar, Dampers and Steering
Version 1 2016-01-01 51 / 113
Attention
- It must always be guaranteed that the ride-height is within the permitted
range when measured at the FIA measurement points!
- The maximum adjustable extended damper length must not be exceeded!
A groove on the push rod thread marks the maximum permitted position
(see Image 14). The groove must remain within the lower damper eye!
Image 14: Push Rod Thread With Groove
Marking
Image 15: Lower Damper Eye in Maximum
Permitted Position
The maximum droop travel can be adjusted using the spring platform on the
damper body. The thread pitch of the spring platform and locking nut is 1.5
mm.
Front axle spring platform
Rear axle spring platform
On damper
On damper
On wheel
On damper
On damper
On wheel
1.00 turn
1.500 mm
1.80 mm
1.00 turn
1.500 mm
1.86 mm
0.56 turns
0.835 mm
1.00 mm
0.54 turns
0.808 mm
1.00 mm