Audi R8 LMS 2018 - Front Axle Pushrod Adjustment; Rear Axle Pushrod Adjustment; Damper Adjustment (Compression;Rebound)

400 – Front Axle, Anti-Roll Bar, Dampers and Steering
Version 1 2016-01-01 52 / 113
The ride height can be set on the push rod. The thread pitch on the push rod is 1
mm.
Front axle pushrod
Rear axle pushrod
On damper
On damper
On wheel
On damper
On damper
On wheel
1.00 turn
1.000 mm
1.20 mm
1.00 turn
1.000 mm
1.24 mm
0.84 turns
0.835 mm
1.00 mm
0.81 turns
0.808 mm
1.00 mm
The static corner weights can be adjusted on the spring platform on the damper
body or on the push rod.
Damper Adjustment
The compression setting is adjusted on the gold wheel
marked with ‘COMP’. The rebound setting is adjusted on
the black wheel marked with ‘REB’. Rotate clockwise to
increase the damping forces.
Rotate anticlockwise to reduce the damping forces.
To reset the adjustment, the wheel must be rotated
clockwise to the mechanical stop (position 0). Afterwards,
rotate anticlockwise click by click to open the valve again.
Count the clicks until the desired value is achieved.
Attention
Do not use excessive force to rotate the adjuster wheels. Sensitive sealing
surfaces could be damaged!