700- Pneumatic Gearshift and Pedals
Version 1 2016-01-01 68 / 113
Procedure to Adjust the Longitudinal Position of the Sledge
- Ensure that the pneumatic reservoir is charged with sufficient pressure, or
switch on the MAIN switch and wait until the compressor switches off
- Press the button valve in the centre console
- Move the sledge to the desired position by pushing below the throttle
pedal plate with the heel of the right foot
- Release the button valve in the centre console
- The next closest locking position is achieved by pushing the sledge with
the right heel or by releasing the sledge
- Check that the sledge is securely locked by pushing with the feet
To Next Page
Loading...
