700- Pneumatic Gearshift and Pedals
Version 1 2016-01-01 72 / 113
- Swing the damper to the right (see Image 27)
- Rotate the damper clockwise --> stiffer damping
- Rotate the damper anticlockwise --> softer damping
While rotating pull lightly on the cylinder so that the adjustment gears engage
in the piston.
When the resistance increases noticeable while rotating stop the adjustment!
Attention
Do not use force to rotate otherwise the adjuster segment in the damper can be
damaged!
Attention
The driver’s foot can get tired if the damper is set too hard.
- Remount the damper using the bolt
- To check the pedal force required press the pedal at different speeds to
simulate throttle application
- Remount the gas spring used to adjust the sledge position
- Refit the pedal unit cover (4 bolts)
- Sit in the driver’s seat and check the force required to press the throttle
pedal. Do this at different speeds to simulate throttle application.
To Next Page
Loading...
