Audi R8 LMS 2018 - Minimum Ride Height Specifications; Rear Wing Position Check

801- Aerodynamics
Version 1 2016-01-01 85 / 113
Minimum ride height (see chapter 800 - 1.1 Homologation)
Front
Rear
- Measured on the floor beneath the axles:
54 mm
54 mm
- Measure on the FIA reference points on the
chassis:
65.5 mm
128 mm
Rear wing position (see chapter 800 - 1.1 Homologation)
Ensure that the Gurney flap – uppermost edge of the rear wing – is within the
homologated dimension at all times!
The position of the Gurney can be checked by using the rear wing jig V03 862
704 CB TEMPLATE REAR WING. If the rear wing is not in the window, the wing
supports must be tilted forwards or backwards in X around the lower mounting
point.