Audi R8 LMS 2018 - Electric and Data Acquisition; RaceCon Software; Going Online with RaceCon System

900- Electric and Data Acquisition
Version 1 2016-01-01 87 / 113
900- Electric and Data Acquisition
900 - 1 Software
RaceCon
BOSCH Motorsport supplies the RaceCon software with which the majority of
functions of the R8 LMS can be parameterised. This includes common functions
such as:
- Creation of display pages
- Lap trigger configuration
- Outing and lap counter configuration
- Pit speed configuration
- Suspension travel calibration (optional)
- Steering angle calibration
- Calibration of engine functions (butterflies, throttle pedal, camshafts)
The R8 LMS is delivered with a ready-to-race RaceCon configuration. Adapting
the display pages and additional functions is not necessary. If changes are
desired and teams are still unfamiliar with RaceCon, please do not hesitate to
contact customer support at Audi Sport customer racing.
a) Going online with the system
To make changes in the RaceCon project a connection with the car must be
created. This is made via the diagnostic plug at the passenger door.
Some factors can be changed offline in the project and subsequently
downloaded to the car after connecting.
The following data can be changed offline:
- Views and configuration of the DDU
- Lap trigger values
- Changes in the logger