900- Electric and Data Acquisition
Version 1 2016-01-01 92 / 113
Important: When calibrating or adjusting, every calibration and adjustment can
only be made if the ECU is connected (status green). After calibration, the
calibration conditions must always be reset to FALSE and/or ‘0’.
1. Overview of engine and gearbox temperatures and pressures
2. Calibration camshaft
- Run the engine at idle speed; toil > 65 °C
- Start camshaft adaptation when calibrating condition 15 is
written in the calibration channel CWCAMADAP and
confirmed by pressing ‘enter’
- Wait until the adaptation status (cam_adapt_sate_x)
indicates successful for all camshafts
- If this is not the case, the procedure must be repeated!
- Camshaft adaptation is finished when calibrating condition
‘0’ is written in the calibration channel CWCAMADAP and
confirmed by pressing ‘enter’
3. Calibration linear potentiometer damper (‘define 0’)
- Set calibrating condition of calibration channel from FALSE
to TRUE and back to FALSE
To Next Page
Loading...
