Audi R8 LMS 2018 - Throttle Pedal Calibration; Clutch Pedal Calibration; Gearbox Potentiometer Check;Adjustment; Butterfly Calibration

900- Electric and Data Acquisition
Version 1 2016-01-01 93 / 113
4. Calibration throttle pedal
- Press the throttle pedal to the mechanical stop (full throttle)
– activate status ‘calibrate full pressed pedal’
- Release throttle pedal and/or do not press – activate status
‘calibrate release pedal’
- Reset status to ‘calibration inactive’
5. Calibration clutch pedal
- Pull right clutch paddle to mechanical stop – activate status
‘calibrate full-pulled paddle’
 Do not pull clutch paddle – activate status ‘calibrate
release paddle’
 Reset status to ‘calibration inactive’
- Pull left clutch paddle to mechanical stop – activate status
‘calibrate full-pulled paddle’
 Do not pull clutch paddle – activate status ‘calibrate
release paddle’
 Reset status to ‘calibration inactive’
6. Checking / basic adjustment gearbox potentiometer
- Set the gearbox potentiometer to 1.2 volts when Neutral (N)
selected; see also chapter 901 - 1.1 Checking / Adjusting
Gearbox Potentiometer
7. Calibration butterflies
- Activate status ‘automatic calibration’
- As soon as the calibration is complete reset status to
‘calibration inactive’
8. Calibration steering angle sensor
- Rotate steering wheel 180° to the left – activate status ‘cal
left’
- Rotate steering wheel 180° to the right – activate status ‘cal
right’