Navigating the menu
Use the rocker switch on the windshield wiper
lever and the
I RESET ! button to operate the
menu and carry out inquiries and selections .
Fig. 15 Wiper lever: Controls for t he men u display
Fig. 16 Display: Start menu
I RESETI button @ and rocker swit ch @
¢ fig. 15 functions:
To open the menu
• Press the I RESET I button @ until the menu
display¢ fig. 16 appears.
Selections and setting s
• Press the rocker switc h @ to reach a menu
display. The sw itch is operated the same as
the d isplay (up/down).
Entering and confirming
• Press the !RESET I button @ .
Returning to the Start menu
• Press the I RESET I button longer than 2 sec-
onds to ret urn from any menu leve l to t he
Start menu .
Using t he rocker switch, you can select t he
menus in the d isp lay or change se tt ings. A
Dr iv er in f ormation system 25
cursor appea rs on the left in front of these-
lected values .
By press ing the
!RESET I button, you act ivate
the selec t ion you made or confi rm the val ues
you set.
Selected functions are identified with
a check mark or are carried out directly .
Mean ings of t he symbols in the display :
Selec-
tion bar
>
./
D
Selected funct ion Mean ing
Cursor
Check mark
Box
Curren t Selec-
tion
Selected or
Function active
Not selected
Triangle pointi ng Previous pag e
up
Triangle pointing Next page
down
Selecting settings
The Driver Information System settings are
menu-guided .
Fig. 1 7 Display: Menu Settings, computer selected
(page
1)
• Press the I RESE T ! button. The Start menu
appears ¢ page 24, fig. 14.
• Press the rocker switch unt il Set is dis-
played .
• Press the
I RESET ! button . All the me nus ap-
pea r.
• Press t he rocker switch unt il the desired line
is highlig hted (curso r)
¢fig. 17 .
• Press the I RESET I button. 111-
To Next Page
Loading...
