The top row shows the current lap number: e .
g.
LAP 2 (= second lap).
Starting lap time
~
Press the uppe r section of the rocker switch.
Row @ <>
fig . 20 d isplays t he curre nt lap
t ime .
Saving lap time
~
Press the upper section of the rocker switch
again . This s imultaneo usly starts the meas-
urement for the next lap.
After being saved, the first recorded lap time
moves from the lowest to the next highest
line in the display (D
r=.>fig. 21 . The lowe r line
@ identifies the new ly started lap time.
Recording addit ional lap times
Fig. 22 Display: Lap 2 is saved
After starting the lap timer, a timed lap is
comp leted and sto red and t iming beg ins for
the next lap every time the upper sect ion of
the rocke r switch is pressed. Contin ue as de-
scr ibed above to measure add it iona l lap
times.
The cu rrent lap time is disp layed in t he bot-
t om line of the display © ¢
fig. 22.
Afte r being saved, the last reco rded lap time
moves from the lower to the next higher line
on t he display @ ¢
fig . 22 . The lap ti me be -
fo re the last one also moves up o ne line @ .
The lowest line © identifies the newly star t ed
lap time .
Dr iv er in f ormation system 2 7
Displaying split time or inserting a
pause
Split time is indicated by a star .
Fig. 23 Displ.ay: Show ing a split tim e
It is possible to recall split times for speci fic
stretches. If you would like to insert a pause
during a lap, you can stop the time recording .
Displaying split time or inserting a pause
~
Press on the lower section of the rocker
switch to
display the split time © - While
the split time marked with a star is be ing
disp layed, the t ime recording cont inues to
run in the background .
~
Press the lower se ction of the rocker switch
again to
insert a pause. Timing is interrupt·
ed, the star in the last row disappears .
Resuming tim ing
~
Press the upper sect ion of the rocker switch
to resume t iming from the split time or
pause display .
Switching the display between the lap
timer and trip computer
You can ret rieve info rmation from t he t rip
compu t er wh ile t he lap timer stopw atc h is
runn ing .
Selecting the tr ip computer
~
Press t he I RESET I button br iefly to display
t he t rip computer . You can now operate t he
tr ip computer as usual.
Selecting the lap t imer
~
Press the I RESET I button until t he lap timer
r=.> page 26, fig . 19 appears .
To Next Page
Loading...
